LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1987 >> Legend LS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Electronic Engine Control System >> Diagnosis & Testing >> Code 8: TDC Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 8: TDC Sensor

  1. Turn ignition off. Disconnect alternator sense fuse in under hood relay box for 10 seconds to reset ECU. Start engine and check for PGM-FI warning light on or off. If light is off, test drive and check again.
  2. If light is on, turn engine off. Disconnect sensor connector nearest the sensor. Measure resistance between Orange/Blue terminal and White/Blue terminal. If ohm reading is not 500-1200 ohms (on Sedan) or 500-1000 ohms (on Coupe), replace sensor. If ohm reading is within specifications, go to next step.
  3. Check continuity between ground and Orange/Blue terminal. Check continuity between ground and White/Blue terminal. If continuity exists, replace sensor. If no continuity exists, go to next step.
  4. Reconnect sensor connector. Attach system checker harness to right side wire harness only, not to ECU. Using an ohmmeter, check resistance between connector terminal No. C3 and C4. Resistance should be 500-1200 ohms (on Sedan) or 500-1000 ohms (on Coupe).
  5. If resistance not within specifications, repair open in Orange/Blue and/or White/Blue wire. If resistance is within specifications, connect a known good ECU and recheck. Replace ECU if original is defective.
scientia non olet · About LEMON Manuals