LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1990 >> Integra LS, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Idle Control System >> Automatic Transmission Shift Position Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Automatic Transmission Shift Position Signal

  1. While watching the shift indicator, shift to transmission gear to each position. If shift indicator lights up correctly for all positions, turn ignition off. Connect PGM-FI test harness between the ECU and ECU connectors. Disconnect connector "B" from main harness only; DO NOT  disconnect from ECU. Turn ignition on. Measure voltage between ECU terminals B7 (positive) and A18 (negative). If voltage is NOT around 10 volts, substitute a known good ECU and recheck voltage.
  2. If voltage is approximately 10 volts, reconnect connector "B" to main wiring harness. Place transmission in Neutral. measure voltage between terminals B7 (positive) and A18 (negative). If there is more than 1 volt, repair open in Light Green wire between ECU B7 and connector.
  3. If voltage is NOT more than 1 volt, place transmission in Park and measure voltage between terminals B7 (positive) and A18 (negative). If voltage is more than 1 volt, replace shift position signal.
  4. If not, place transmission in Drive and measure voltage between terminals B7 (positive) and A18 (negative). If voltage is NOT about 10 volts, repair short in Light Green wire between ECU terminal B7 and combination meter. If voltage is approximately 10 volts, shift position signal is okay.
scientia non olet · About LEMON Manuals