LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1991 >> Legend Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Idle Control System >> Air Conditioning Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Air Conditioning Signal

  1. Connect PGM-FI test harness between the ECU and ECU connectors. Disconnect connector "C" from main harness only; DO NOT  disconnect from ECU. Turn ignition on.
  2. Measure voltage between ECU terminals C3 (positive) and A26 (negative). If voltage is not about 10 volts, substitute a known good ECU, and recheck voltage.
  3. If voltage is about 10 volts, reconnect connector "C" to main wiring harness. Touch terminals A15 to A26 together and check for clicking of A/C clutch.
  4. If A/C clutch clicks, go to next step. If A/C clutch does not click, jumper Red/Blue wire of A/C clutch connector to ground. If A/C clutch clicks, repair open in Red/Blue wire. If A/C clutch still does not click, repair A/C clutch circuit.
  5. Start engine, and turn blower on. Turn A/C switch on. If A/C operates, A/C signal is okay. If A/C does not operate, measure voltage between terminals C3 (positive) and A26 (negative).
  6. If voltage is more than 1 volt, repair open in Blue/Black wire between C3 and cooling fan control unit. If voltage is less than 1 volt, substitute a known good ECU, and recheck voltage.
scientia non olet · About LEMON Manuals