LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1992 >> Integra GS-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Controls - Tests W/Codes) >> Trouble Code Identification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Trouble Code Identification

WARNING: This page is about a different car, the 1992 Acura Legend. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLE CODE IDENTIFICATION CHART (1)

Code System Affected Probable Cause
0  ECU No Signal To ECU
1  O2 Sensor (Left) Open/Shorted Signal Circuit
2  O2 Sensor (Right) Open/Shorted Signal Circuit
3  MAP Sensor MAP Sensor Electrical Problem
4  Crank Angle Sensor No. 1 Sensor Circuit Problem
5  MAP Sensor MAP Sensor Mechanical Problem
6  Coolant Temp. Sensor (TW) Open/Shorted Signal Circuit
7 (2) Throttle Angle Sensor Open/Shorted Signal Circuit
9  No. 1 Cylinder Position Sensor Problem In CYL Sensor Circuit
10  Intake Air Temperature Sensor Open/Shorted Signal Circuit
12  EGR System No EGR Action
13  Atmospheric Pressure Sensor Open/Shorted Signal Circuit
14  Electronic Air Control Valve (EACV) EACV Circuit Problem
15  Ignition Output Signal Open/Shorted Signal Circuit
16  Fuel Injector Open/Shorted Signal Circuit
17 (2) Vehicle Speed Sensor (VSS) No VSS Signal
18  Ignition Timing Adjustment Open/Shorted Signal Circuit
23  Left Knock Sensor Open/Shorted Signal Circuit
41  Left O2 Sensor Heater Open/Shorted Signal Circuit
42  Right O2 Sensor Heater Open/Shorted Signal Circuit
43  Left Fuel Supply System Open/Shorted O2 Circuit
44  Right Fuel Supply System Open/Shorted O2 Circuit
45  Left Fuel Metering Injector Control
46  Right Fuel Metering Injector Control
53  Right Knock Sensor Open/Shorted Signal Circuit
54  Crank Angle Sensor No. 2 Sensor Circuit Problem
59  No. 2 Cylinder Position Problem In CYL Sensor Circuit
(1)
If codes other than these are indicated, repeat self-diagnosis. If code(s) reappear, substitute a known good ECU, and recheck codes. If code(s) clear, replace ECU.
(2)
If S4 on automatic transaxle indicator panel also blinks, A/T control unit may also require diagnosis.