Fuel Pump Relay
- Remove main relay, located at left side of cowl. Check for continuity between relay terminals No. 1 and 3. If continuity exists, replace relay. If continuity does not exist, proceed to the next step. See Fig 1
.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Check for continuity between relay terminals No. 5 and 7. If continuity exists, replace relay. If continuity does not exist, go to next step.
- Using a fused jumper wire, connect positive battery terminal to relay terminal No. 4. Connect relay terminal No. 8 to ground. Check for continuity between relay terminals No. 5 and 7. If continuity exists, go to next step. If continuity does not exist, replace relay.
- Connect battery positive terminal to relay terminal No. 6. Connect negative battery terminal to relay terminal No. 2. Check for continuity between relay terminals No. 1 and 3. If continuity exists, go to next step. If continuity does not exist, replace relay.
- Connect battery positive terminal to relay terminal No. 3. Connect battery negative terminal to relay terminal No. 8. Check for continuity between relay terminals No. 5 and 7. If continuity exists, relay is okay. If continuity does not exist, replace relay.