Code 17 - Vehicle Speed Sensor (VSS)
- Turn ignition off. Remove ACG fuse (No. 15, 7.5-amp) from underdash fuse box for 10 seconds to reset ECM. Road-test vehicle. While in 2nd gear, accelerate until engine speed reaches 4000 RPM and then, with throttle fully closed, decelerate to 1500 RPM.
- Retrieve codes. If Code 17 does not appear, problem is intermittent. Inspect for poor connections at ECM, VSS, and wiring harness connectors. Test-drive vehicle and retest.
- If Code 17 exists, raise and support vehicle. Connect ECM Test Harness (07LAJ-PT3010A ) between ECM and ECM harness. See Figure . Place transaxle in Neutral. Turn ignition on. Block right front wheel. Slowly rotate left front wheel while measuring voltage between test terminals A26 (-) and C2 (+). If voltage pulses 0-5 volts, temporarily substitute known good ECM, then retest system.
- If voltage does not pulse 0-5 volts, turn ignition off. Unplug connector "C" from ECM. Turn ignition on. Rotate left front wheel. If voltage does not pulse 0-5 volts, repair short or open in Yellow/Red wire between ECM terminal C2 (+) and VSS. If wire is okay, replace VSS. If voltage pulses 0-5 volts, temporarily substitute known good ECM, then retest system.