Steering Column Tilt/Extend-Retract Switch
CAUTION:
Before disconnecting any part of the SRS wire harness, install the short connectors. Do not disassemble or tamper with the airbag assembly.
- Pry the courtesy light controller and TCS switch (LS) out from the dashboard lower cover, then remove the three screws, and remove the dashboard lower cover.
- Remove the steering column tilt cover.
- Remove steering column upper and lower covers. Remove steering column switch from lower cover.
- Check continuity between the switch terminals. See STEERING COLUMN SWITCH CONTINUITY table. See Fig 1 . If resistance is not as specified, replace steering column. See STEERING COLUMN (1994) or STEERING COLUMN (1995) article in STEERING.
STEERING COLUMN SWITCH CONTINUITY
| Switch Position | Between Terminals | |
|---|---|---|
| Tilt Switch | ||
| Up | C & E | |
| Down | B & C | |
| Extend/Retract Switch | ||
| Retract | C & D | |
| Extend | A & C | |
| Auto Switch On | F & G | |