LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1996 >> Integra GS-R, 2D Coupe >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Circuit Tests >> Code 4-4: Right Rear Wheel Speed Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 4-4: Right Rear Wheel Speed Sensor

  1. Disconnect right rear wheel speed sensor 2-pin connector. Measure resistance between speed sensor connector terminals. If resistance is not 700-1100 ohms, replace speed sensor. If resistance is 700-1100 ohms, go to next step.
  2. Check continuity between Green/Yellow wire terminal of speed sensor connector and ground. If continuity exists, replace speed sensor. If continuity does not exist, disconnect ABS control unit 22-pin connector. Check continuity between Green/Yellow wire terminal of ABS control unit 22-pin connector and ground.
  3. If continuity exists, Green/Yellow wire between ABS control unit and speed sensor is shorted to ground. If continuity does not exist, check continuity between Blue/Yellow wire terminal of ABS control unit 22-pin connector and ground.
  4. If continuity exists, Blue/Yellow wire between ABS control unit and speed sensor is shorted to ground. If continuity does not exist, reconnect speed sensor 2-pin connector. Measure resistance between Green/Yellow wire and Blue/Yellow wire terminals of ABS control unit 22-pin connector.
  5. If resistance is 700-1100 ohms, go to step 7). If resistance is not 700-1100 ohms, connect jumper wire between Green/Yellow wire terminal of ABS control unit 22-pin connector and ground. Disconnect right rear speed sensor 2-pin connector.
  6. Check continuity between speed sensor harness connector Green/Yellow wire terminal and ground. If continuity exists, repair open Blue/Yellow wire between ABS control unit and speed sensor. If continuity does not exist, repair open Green/Yellow wire between ABS control unit and speed sensor.
  7. Check right rear speed sensor air gap and correct if necessary. See WHEEL SENSOR AIR GAP SPECIFICATIONS  table under REMOVAL & INSTALLATION. If gap is okay, go to next step.
  8. Connect ABS tester to inspection 6-pin connector. See Figure . Start engine. Turn mode selector on ABS tester to mode 3. Firmly depress and hold brake pedal down. Push START TEST switch.
  9. Have assistant manually rotate right front wheel. If wheel cannot be rotated, replace modulator. If wheels can be rotated, problem is intermittent. Test drive vehicle. If symptom reappears, replace ABS control unit.
scientia non olet · About LEMON Manuals