DTC P0505: Idle Control System
NOTE:
If DTC P1508 is set, at the same time as DTC P0505, trouble shoot DTC P1508 first.
- If DTC P0505 is set, check the following:
- IAC valve mechanical malfunction.
- Fast idle thermo valve malfunction.
- Clogged throttle body port or improper adjustment.
- Intake manifold and/or manifold gasket leak.
- Intake air hose loose and/or leaking.
- Vacuum hose leaks.
- Incorrect ECT sensor signal.
Repair as necessary. If no problems are found, go to next step.
- Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Go to next step.
- Check idle speed data under no-load conditions (all accessories off), using scan tool. See IDLE SPEED SPECIFICATIONS
. If idle speed is within specification, problem is intermittent, system is okay at this time. If idle speed is less than minimum specification, go to next step. If idle speed is more than maximum specification, go to step 5).IDLE SPEED SPECIFICATIONS
Application Specification 3.2TL 590-690 RPM - Disconnect IAC valve 2-pin connector. If engine speed drops or engine stalls, adjust base idle speed. If base idle speed cannot be adjusted, clean ports in throttle body. If engine speed does not drop, replace IAC valve.
- Turn ignition off. Remove cover from fast idle thermo valve. See Fig 1 . Start engine and allow to idle. Feel for airflow at valve seat. If airflow does not exist in valve seat area, go to next step. If airflow exists in valve seat area, check coolant level and for air in cooling system. If okay, replace fast idle thermo valve.
- Check for vacuum leaks and ensure throttle valve is fully closed. Adjust idle speed. If idle speed cannot be adjusted, replace IAC.NOTE: After removing/replacing fast idle thermo valve cover, perform PCM reset procedure. See PCM RESET PROCEDURE/CLEARING CODES .