LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1997 >> Integra GS-R, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - Basic Testing - Except GS-R) >> Ignition Checks >> Engine Controls - Basic Testing - Except GS-R >> Ignition Coil Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition Coil Test

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition off. Remove distributor cap. Remove screws and disconnect Black/Yellow and White/Blue wires from coil. Measure primary winding resistance between primary terminals "A+" and "B-" on ignition coil. See Fig 1 . Resistance should be .6-.8 ohm at 68°F (20°C).
  2. Measure secondary winding resistance between coil terminal "A+" and secondary terminal (coil tower). Resistance should be 12,800-19,200 ohms at 68°F (20°C). Replace coil if resistance is not within specifications.
    Fig 1: Testing Ignition Coil
    G92J26194Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals