2.3CL, 3.0CL, 2.5TL & 3.2TL

Remove dashboard lower cover and knee bolster. Disconnect main harness 8-pin connector. Connect battery voltage (B+) to ignition switch terminal No. 4 and connect ground to terminal No. 2 (B+ to terminal No. 8 and ground to terminal No. 2 on 2.5TL & 3.2TL). See Figure . Light Emitting Diode (LED) should come on. If LED does not come on, replace LED. See IGNITION SWITCH  under REMOVAL & INSTALLATION.