DTC P1359: CKP/TDC/CYP Sensor Circuit Problem Detected
- Perform PCM reset procedure. See PCM RESET PROCEDURE/CLEARING CODES under SELF-DIAGNOSTIC SYSTEM. Start engine. If DTC P1359 resets, go to next step. If DTC 1359 does not reset, problem is intermittent. System is okay at this time. Check for poor connections or loose wires between Crankshaft Position/Top Dead Center/Cylinder Position (CKP/TDC/CYP) sensor and PCM. See WIRING DIAGRAMS article. Repair as necessary.
- Check for poor connections or loose wires between, CKP/TDC/CYP sensor and PCM. See WIRING DIAGRAMS article. If wiring and connections are okay, substitute a known-good PCM, then recheck. If symptom or indication goes away, replace original PCM.