LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2000 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Idle Control System >> Generator Fr Signal >> 3.5RL
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Generator Fr Signal: 3.5RL

  1. Disconnect Green 4-pin connector from generator. Turn ignition on. Measure voltage by backprobing between PCM 26-pin connector "A" terminal No. 26 (Brown/Black wire) and PCM 22-pin connector "D" terminal No. 5 (White/Red wire). See Figure. If voltage is not about 5 volts, go to next step. If voltage is about 5 volts, go to step  3.
  2. Turn ignition off. Disconnect negative battery cable. Disconnect PCM 22-pin connector "D". Check continuity between ground and PCM 22-pin harness connector "D" terminal No. 5 (White/Red wire). See Figure. If continuity exists, repair short circuit in White/Red wire between PCM 22-pin connector "D" terminal No. 5 and generator. If continuity does not exist, substitute a known-good PCM from a donor vehicle, then recheck. Cut temporary key from a non-immobilizer key blank and tape donor vehicle key to it backwards in order to deactivate immobilizer system during testing. If voltage measured in previous step is now about 5 volts, replace original PCM.
  3. Turn ignition off. Reconnect generator Green 4-pin connector. Start engine and run it at 3000 RPM, with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Measure voltage by backprobing between terminals PCM 26-pin connector "A" terminal No. 26 (Brown/Black wire) and PCM 22-pin connector "D" terminal No. 5 (White/Red wire). See Figure. Turn headlights and rear defogger on. If voltage does not decrease, go to next step. If voltage decreases, generator FR signal is okay.
  4. Turn ignition off. Disconnect negative battery cable. Disconnect PCM 22-pin connector "D". Disconnect generator Green 4-pin harness connector. Using a jumper wire, connect generator Green 4-pin harness connector terminal No. 4 (White/Red wire) to ground. Check for continuity between ground and PCM 22-pin harness connector "D" terminal No. 5 (White/Red wire). See Figure. If continuity does not exist, repair open in White/Red wire between PCM 22-pin connector "D" terminal No. 5 and generator. If continuity exists, check generator performance. See appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
scientia non olet · About LEMON Manuals