Integra & 3.2TL

Measure voltage by backprobing between PCM 32-pin connector "A" terminal No. 24 (Blue/White wire on Integra, Blue/Orange wire on 3.2TL) and PCM 25-pin connector terminal No. 20 (Brown/Black wire on Integra, Brown/Yellow wire on 3.2TL) with ignition switch in START position. See Figure. If battery voltage is present, starter signal is okay. If battery voltage is not present, inspect STARTER SIGNAL fuse No. 13 (7.5-amp) located in underdash fuse/relay block. If fuse is okay, repair open circuit in Blue/White wire on Integra or Blue/Orange wire on 3.2TL between PCM 32-pin connector "A" terminal No. 24 and fuse. If fuse is blown, repair short circuit in Blue/White wire on Integra or Blue/Orange wire on 3.2TL between PCM 32-pin connector "A" terminal No. 24 and fuse or PGM-FI main relay. Replace fuse.