Removal (Front)
- Remove door panel and plastic cover. See DOOR PANEL
. Ensure power window switch is connected. Raise window glass until mounting bolts are visible. Using a grease pencil, mark original adjustment position of stopper plates.
- Mark original adjustment position of glass mounting bolts and remove bolts. Carefully slide glass out through window slot. Disconnect electrical connector and harness clip from door. Remove power window motor and regulator mounting bolts "A". See Fig 1
. Loosen power window motor and regulator mounting bolts "B". Remove power window motor and regulator through hole in door. Remove power window motor from regulator.
Courtesy of AMERICAN HONDA MOTOR CO., INC.