3.2CL & 3.2TL

WARNING: This page is about a different car, the 2004 Acura 3.5RL, 2003 Acura 3.5RL, 2003 Acura 3.2TL, and 2003 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.

Measure voltage by backprobing between PCM 32-pin harness A connector terminal No. 24 (Blue/Orange wire) and PCM 25-pin harness B connector terminal No. 20 (Brown/Yellow wire - A/T) or ECM 31-pin harness A connector terminal No. 26 (Brown/Yellow wire) and ECM 32-pin harness E connector terminal No. 8 (Blue/Orange wire - M/T) with ignition switch in START position. See Figure or Figure . If battery voltage is present, starter signal is okay. If battery voltage is not present, inspect No. 13 STARTER SIGNAL (7.5-amp) fuse in underdash fuse/relay box. If fuse is okay, repair open in Blue/Orange wire between PCM 32-pin harness connector terminal No. 24 (A/T) or ECM 32-pin harness E connector terminal No. 8 (M/T) and under-dash fuse/relay box 18-pin harness connector terminal No. 18. If fuse is blown, repair short in Blue/Orange wire between PCM 32-pin harness connector terminal No. 24 (A/T) or ECM 32-pin harness E connector terminal No. 8 (M/T) and under-dash fuse/relay box 18-pin harness connector terminal No. 18 and between under-dash fuse/relay box 22-pin harness connector terminal No. 10 and PGM-FI main relay harness connector terminal No. 2. Replace fuse.