Power Window Master Switch: Hatchback
Remove power window master switch. See WINDOW SWITCH under REMOVAL & INSTALLATION. Disconnect 10-pin connector. Check for continuity between master switch terminals with switches in specified position. See POWER WINDOW MASTER SWITCH - HATCHBACK table. See Fig 1 . If continuity is not as specified, replace affected switch.
NOTE:
Driver's power window switch is integrated with control unit and cannot be isolated for testing.
Perform power window master switch tests No. 1, 2, 3, and 5. See Figure . If inputs are normal and driver's power window switch does not operate properly, replace power window master switch assembly.
POWER WINDOW MASTER SWITCH - HATCHBACK (1)
| Window Switch Position | Master Switch Position | Continuity Between Terminals | |||
|---|---|---|---|---|---|
| Right Front Switch | |||||
| Off | On | D, H & I | |||
| Off | H & I | ||||
| Up | On | D & H; I & J | |||
| Off | I & J | ||||
| Down | On | D & I; H & J | |||
| Off | H & J | ||||
|
|||||