Key Interlock Solenoid/Switch
- Remove the driver's dashboard lower cover. See DASHBOARD LOWER COVER under REMOVAL & INSTALLATION.
- Remove screws from lower steering column cover. Remove upper and lower steering column covers. Disconnect the key switch connector (7 pin) from the steering lock assembly.
- Check for continuity between the No. 5 and 7 terminals when the key is pushed, and check for no continuity when the key is released. See Figure.
- Check that the key cannot be removed with power connected to the key switch component connector No. 7 terminal and ground connected to the No. 3 terminal.
- If the key cannot be removed, the key interlock solenoid is okay.
- If the key can be removed, replace the steering lock assembly (the key interlock solenoid is not available separately). See appropriate STEERING COLUMNS article in STEERING.