Customer Supplied Only One Valid Key
- Cut new transponder equipped key(s), if necessary. After PCM has been replaced. Using new first key, turn ignition switch to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new first key to LOCK position.
- Using valid key, turn ignition switch to ON position, then LOCK position 6 times. DO NOT leave key in either position for more than one second. Ensure sixth turning is done within one second. SECURITY light should be flashing at a 300-millisecond interval. Wait about 5 minutes until SECURITY light flashing has decreased to a 1.2-second interval.
- Input code word. See INPUTTING CODE WORD . SECURITY light should stop flashing and stay illuminated. Using valid key, turn ignition switch to ON position. SECURITY light should illuminate for 1-2 seconds. Turn valid key to LOCK position and remove key.
- Using new second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new second key to LOCK position and remove key.
- Repeat step 4 with each new key, up to 8 keys total. Wait 30 seconds, program will quit automatically. After reprogramming is complete, clear DTCs with New Generation Star (NGS) tester.