LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2003 >> 3.2CL Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation (MDX)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (MDX)

CAUTION:

On MDX, the PCM overwrites data and monitors the EVAP system for up to 60 minutes after the ignition is turned off. Jumping the SCS line after turning ignition off cancels this function. Disconnecting the PCM during this function, without jumping the SCS line first, can damage the PCM. When removing/installing PCM or disconnecting PCM connectors, steps  1- 3 must be followed to protect the powertrain control module (PCM) from damage, or wait at least 60 minutes before disconnecting. See the following:

NOTE: PCM is located in the right side of engine compartment towards the front of vehicle.
  1. With ignition on, connect the Honda PGM Tester or the HDS to the data link connector (DLC), and go into any of the live data screens.
  2. Turn ignition off.
  3. Turn the Honda PGM Tester off or close the HDS and then back on. Go to the SCS mode and follow the screens to ground the 16-pin DLC.
  4. Remove cover from PCM.
  5. Disconnect PCM harness connectors "A" and "B". Remove bolts and PCM.
  6. Install PCM in reverse order of removal.
scientia non olet · About LEMON Manuals