Rack Guide Adjustment

Special Tools Required 

Locknut wrench, 40 mm 07916-SA50001

1. Set the wheels in the straight ahead position.
2. Loosen the rack guide screw locknut (A) with the special tool, then remove the rack guide screw (B).
   Fig 1: Loosening The Rack Guide Screw Locknut

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the old sealant from rack guide screw, and apply new sealant all around the threads (C).

   Loosely install the rack guide screw on the steering gearbox.

   Fig 2: Backing Off The Rack Guide Screw

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Tighten the rack guide screw to 25 N.m (2.5 kgf.m, 18 lbf.ft) then back it off to specified angle.

   Specified Return Angle: 20° Max. 

5. Tighten the locknut while holding the rack guide screw.
6. Check for unusual steering effort through the complete turning travel.
7. Check the steering wheel rotational play and the power assist (see STEERING WHEEL ROTATIONAL PLAY CHECK  and POWER ASSIST CHECK ).