LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2004 >> TL Standard >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI System >> Injector Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Injector Replacement

  1. Relieve fuel pressure (see FUEL PRESSURE RELIEVING ).
  2. Remove the intake manifold (see REMOVAL ).
  3. Disconnect the connectors from the injectors (A).
    Fig 1: Disconnecting Connectors From Injectors
    G03659525Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the quick-connect fittings (B).
  5. Remove the fuel rail mounting bolts (C) from the fuel rail (D).
  6. Remove the injector clip (E) from the injector.
  7. Remove the injector from the fuel rail.
  8. Coat the new O-rings (A) with clean engine oil, and insert the injectors (B) into the fuel rail (C).
    Fig 2: Inserting Injectors Into Fuel Rail
    G03659526Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Install the injector clip (D).
  10. Coat the new injector O-rings (E) with clean engine oil.
  11. Install the injectors in the injector base (F).
  12. Install the fuel rail mounting nuts.
  13. Connect the connectors on the injectors.
  14. Connect the quick-connect fittings (see FUEL LINE/QUICK-CONNECT FITTING INSTALLATION ).
  15. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel rail will be pressurized. Repeat this two or three times, then check for fuel leakage.
  16. Install the intake manifold (see INSTALLATION ).
scientia non olet · About LEMON Manuals