LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Driver Position Memory System (DPMS) >> Power Tilt/Telescopic Steering Control Unit Input Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Tilt/Telescopic Steering Control Unit Input Test

NOTE: Before testing, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
  1. Turn the ignition switch OFF.
  2. Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ), and the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ), then remove the steering column covers (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
  3. Disconnected the 16P connector (A) and 8P connector (B) from the power tilt/telescopic steering control unit (C).
    Fig 1: Identifying 16P Connector, 8P Connector And Power Tilt/Telescopic Steering Control Unit
    G05497336Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
    • If the terminals look OK, go to step 5.
  5. Reconnect the connectors to the power tilt/telescopic steering control unit, and make these input tests at the connectors.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, the control unit must be faulty; replace it.
      WIRE CAVITY CHART

      Cavity Wire Test condition Test: Desired result Possible cause if desired result is not obtained
      A8 BLK Under all conditions Measure the voltage to ground:
      There should be less than 0.5 V.
      • Poor ground(G501)
      • An open in the wire
      B1 BLK
      A1 WHT Under all conditions Measure the voltage to ground:
      There should be battery voltage.
      • Blown No. 15 (40A) fuse in the under-hood fuse/relay box
      • Blown No.7 (10A) fuse in the driver's under-dash fuse/relay box
      • An open in the wire
      A9 YEL(1)
      PNK(2)      		 Ignition switch ON (II) Measure the voltage to ground:
      There should be battery voltage.
      • Blown No.21 (10A) fuse in the driver's under-dash fuse/relay box
      • An open in the wire
      B3 WHT Under all conditions Measure the voltage to ground:
      There should be battery voltage.
      • Blown No. 23 (P/W) (50A) fuse in the under-hood fuse/relay box
      • Blown No.26 (20A) fuse in the driver's under-dash fuse/relay box
      • An open in the wire
      B5 GRN Under all conditions Measure the voltage to ground:
      There should be battery voltage.
      • Blown No. 23 (P/W) (50A) fuse in the under-hood fuse/relay box
      • Blown No.25 (20A) fuse in the driver's under-dash fuse/relay box
      • An open in the wire
      (1) '05 model
      (2) '06-08 models
scientia non olet · About LEMON Manuals