CMP Sensor Replacement
- Set the No. 1 piston at top dead center (see
TIMING BELT REMOVAL
).
- Remove the upper covers from the engine (see step 10 under TIMING BELT REMOVAL
).
- To hold the timing belt adjuster in its current position, thread in the battery clamp bolt hand-tight (see step 14 under TIMING BELT REMOVAL
).
- Loosen the idler pulley bolt about five or six turns, then remove the timing belt from the front camshaft pulley (see step 16 under TIMING BELT REMOVAL
).
- Remove the front camshaft pulley (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Disconnect the CMP sensor connector (B), then remove the back cover (C).
- Remove the CMP sensor (A) from the back cover.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the parts in the reverse order of removal. Reinstall the timing belt (see
TIMING BELT INSTALLATION
) and other removed parts.
- Do the CKP pattern clear/CKP pattern learn procedure (see
CRANK (CKP) PATTERN CLEAR/CRANK (CKP) PATTERN LEARN
).