DTC B1837: Power Seat Position Memory Recall Error

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System, Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).

Clear the DTC with the HDS.
Turn the ignition switch OFF, and then back ON (II).
Operate the power seat with the power seat adjustment switch.
Operate the power seat with the driving position memory switch.
Check for DTCs with the HDS.
Is DTC 1837 indicated?

YES -Go to step 6.

NO -Intermittent failure, the system is OK at this time.
Check for other DTCs.
Is any other DTC indicated?

YES -Go to the INDICATED DTCS TROUBLESHOOTING .

NO -Go to step 7.
Remove the driver's power seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Test the power seat motors (see DRIVER'S POWER SEAT MOTOR TEST ).
Are the power seat motors OK?

YES -Replace the power seat control unit.

NO -Replace the faulty power seat motor(s).