LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> A/T Differential >> Backlash Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Backlash Inspection

  1. Install the driveshaft and intermediate shaft into the differential assembly.
  2. Carefully clamp the driveshaft (A) in a vise (B).
    Fig 1: Measuring Backlash Of Final Driven Gear
    G05496008Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Place the intermediate shaft (C) on a V-block (D), then hold the intermediate shaft with locking pliers (E).
  4. Measure backlash of the final driven gear (F) with a dial indicator (G). If the backlash is not within the standard, replace the differential carrier.

    Standard (New): 1.2-1.8 mm (0.047-0.071 in.) 

scientia non olet · About LEMON Manuals