ATF Cooler Hose Replacement

Slide the ATF cooler hoses over the ATF cooler lines until the hose ends contact the bulge (A) on the ATF cooler lines.

Fig 1: Identifying Gap Between Hose Clip And Hose End
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Secure the hoses with the clips (B) at 6-8 mm (0.2-0.3 in.) (C) from the hose ends.
Secure the hoses at the ATF cooler with the clips (D) at 2-4 mm (0.1-0.2 in.) (E) from the hose ends.
Install the ATF cooler hose (F) on the clamp (G) at the mark (H).