Key Interlock Solenoid Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repairs or service.

1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ) and the lower steering column cover.
2. Disconnect the steering lock assembly connector.
3. Insert the ignition key in the key cylinder, then turn the ignition key to ACCESSORY (I).
4. Connect a jumper wire from the battery positive terminal to steering lock assembly connector terminal No. 4, and connect another jumper wire from the battery negative terminal to No. 3 terminal. Make sure that the ignition key cannot be turned to LOCK (0) position. Disconnect the battery terminals, and make sure that the key can be turned to LOCK (0) position and removed from the cylinder.
   Fig 1: Connecting Jumper Wire From Battery Positive Terminal To Steering Lock Assembly Connector Terminal No. 4

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the key interlock solenoid works improperly, replace the ignition key cylinder/steering lock assembly (see STEERING LOCK REPLACEMENT ).