Driver's Power Seat Motor Test

Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Disconnect the connector from each power seat motor.
NOTE: All connector views are from terminal side of male terminals.

Fig 1: Identifying Driver's Power Seat Motor Connector Terminal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test each motor by connecting power and ground according to the illustrations below. When the motor stops running, disconnect battery power immediately.

Fig 2: Connecting Power And Ground To Test Each Motor (Slide Motor)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Connecting Power And Ground To Test Each Motor (Recline Motor)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 4: Connecting Power And Ground To Test Each Motor (Front Up-Down Motor)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 5: Connecting Power And Ground To Test Each Motor (Rear Up-Down Motor)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If any motor does not run or fails to run smoothly, replace:
- Slide motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY - DRIVER'S 8-WAY POWER )
- Front up-down motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY - DRIVER'S 8-WAY POWER )
- Rear up-down motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY - DRIVER'S 8-WAY POWER )
- Recline motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY - DRIVER'S 8-WAY POWER )