Countershaft Bearing Replacement

Special Tools Required 

• Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A
• Driver 07749-0010000
• Attachment, 78 x 80 mm 07NAD-PX40100

1. Remove the countershaft bearing from the torque converter housing using the adjustable bearing puller, 25-40 mm and a commercially available 3/8 "-16 slide hammer (A).
   Fig 1: Removing Countershaft Bearing From Torque Converter Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the ATF guide plate (A) into the housing, then install a new bearing (B) in the direction shown.
   Fig 2: Identifying ATF Guide Plate And Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the bearing (A) in the housing using the driver and the attachment, 78 x 80 mm; install the bearing outer notch-cut (B) to a depth (C) of 0-0.03 mm (0-0.001 in.) below the housing surface (D).
   Fig 3: Installing Bearing In Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.