Selector Control Shaft Bearing Replacement

Special Tools Required 

• Bearing remover shaft, 10 mm 07936-GE00100
• Bearing remover head, 10 mm 07936-GE00200
• Sliding hammer weight 07741-0010201
• Driver 07749-0010000
• Attachment, 22 x 24 mm 07746-0010800

1. Remove the control shaft bearing from the transmission housing using the bearing remover head, 10 mm, the bearing remover shaft, 10 mm, and the sliding hammer weight.
   Fig 1: Removing Control Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing until it bottoms in the transmission housing using the driver and the attachment, 22 x 24 mm.
   Fig 2: Installing Control Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.