Driver's Power Seat Motor Test

Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION )
Disconnect the connector from each power seat motor
NOTE:
- For the recline motor, remove the seat-back cover (see FRONT SEAT-BACK COVER REPLACEMENT )
- All connectors are terminal side of male terminals
Fig 2: Identifying Recline Motor Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test each motor by connecting power and ground according to the table When the motor stops running, disconnect battery power immediately

Fig 3: Slide Motor Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 4: Recline Motor Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 5: Front Up-Down Motor Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 6: Rear Up-Down Motor Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the motor does not run or fails to run smoothly, replace
- Slide motor (see FRONT SEAT SLIDE MOTOR REPLACEMENT )
- Front up-down motor (see FRONT SEAT FRAME REPLACEMENT )
- Rear up-down motor (see FRONT SEAT FRAME REPLACEMENT )
- Recline motor (see FRONT SEAT RECLINE MOTOR REPLACEMENT )
NOTE: The front and rear up-down motors are part of the seat frame