LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2011 >> MDX >> Repair and Diagnosis >> Body & Frame >> Seats >> Driver Position Memory System (DPMS) >> DTC Troubleshooting >> DTC B2184: Right Power Mirror Horizontal Sensor Signal Error
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B2184: Right Power Mirror Horizontal Sensor Signal Error

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
  1. Clear the DTCs with the HDS.
  2. Turn the ignition switch to LOCK (0) and then back to ON (II).
  3. Move the right power mirror in each direction with the power mirror switch.
  4. Check for DTCs with the HDS.

    Is DTC B2184 indicated? 

    YES  -Go to step 5.

    NO  -Intermittent failure, the system is OK at this time. Check for loose or poor connections.

  5. Select POWER SEAT/POWER MIRROR from the BODY ELECTRICAL SYSTEM SELECT menu, and enter the DATA LIST.
  6. Check the NORMAL/ABNORMAL information of the RIGHT POWER MIRROR HORIZONTAL SENSOR in the DATA LIST.

    Is the information indicator ABNORMAL? 

    YES  -Go to step 7.

    NO  -Replace the front passenger's MPCS unit.

  7. Turn the ignition switch to LOCK (0).
  8. Disconnect front passenger's MPCS unit connector A (28P).
  9. Disconnect the front passenger's door subharness 16P connector.
  10. Check for continuity between front passenger's MPCS unit connector A (28P) terminal No. 6 and front passenger's door subharness 16P connector terminal No. 3.
    Fig 1: Checking Continuity Between Connector (28P) Terminal No. 6 And 16P Connector Terminal No. 3
    G08053962Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Go to step 11.

    NO  -Repair an open in the wire.

  11. Check for continuity between front passenger's door subharness 16P connector terminal No. 3 and body ground.
    Fig 2: Checking Continuity Between 16P Connector Terminal No. 3 And Body Ground
    G08053963Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Repair a short to ground in the wire.

    NO  -Go to step 12.

  12. Check for continuity between front passenger's door subharness 16P connector terminals No. 3 and No. 6.
    Fig 3: Checking Continuity Between 16P Connector Terminals No. 3 And No. 6
    G08053964Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Repair a short in the wires.

    NO  -Go to step 13.

  13. Reconnect front passenger's MPCS unit connector A (28P).
  14. Turn the ignition switch to ON (II).
  15. Measure the voltage between front passenger's door subharness 16P connector terminal No. 3 and body ground.
    Fig 4: Measuring Voltage Between 16P Connector Terminal No. 3 And Body Ground
    G08053965Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there about 5 V? 

    YES  -Replace the right power mirror.

    NO  -Replace the front passenger's MPCS unit.