Driving Position Memory Switch Test/Replacement

Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
Disconnect the 7P connector (A) from the driver's position memory switch (B)

Fig 1: Identifying Driver's Position Memory Switch 7P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two screws, then remove the switch from the door panel
Check for continuity between the terminals in each switch position according to the table

Fig 2: Switch Position Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the switch