Accelerator Pedal Module Removal and Installation: Removal
- Remove the driver's dashboard undercover (see
DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION
)
- Disconnect the APP sensor 6P connector (A)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove the two mounting nuts (B), then remove the clip (C) Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal pad (F) from the pedal stop (G)
- Remove the accelerator pedal module
NOTE:
- The APP sensor is not available separately Do not disassemble the accelerator pedal module
- If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D)
Courtesy of AMERICAN HONDA MOTOR CO., INC.