Air Cleaner Removal/Installation

Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION )
Disconnect the MAF sensor/IAT sensor 5P connector (A)

Fig 1: Identifying MAF Sensor/IAT Sensor 5P Connector, Harness Clamps, Bolt, Band And Air Cleaner Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the harness clamps (B) and the bolt (C)
Loosen the band (D), then remove the air cleaner housing (E)
Install the parts in the reverse order of removal
NOTE: When tightening the screw of the hose band (F), align the edge of the hose band (G) between the marks (H) (or within the mark (I)) painted on the hose band
Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION )