DTC 113: Yaw Rate-Acceleration Sensor Power Source Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to LOCK (0).
- Disconnect the yaw rate-lateral/longitudinal acceleration sensor 4P connector (see YAW RATE-LATERAL/LONGITUDINAL ACCELERATION SENSOR REPLACEMENT ).
- Turn the ignition switch to ON (II).
- Measure the voltage between body ground and yaw rate-lateral/longitudinal acceleration sensor 4P connector terminal No. 1.Fig 1: Measuring Voltage Between Body Ground And Yaw Rate-Lateral/Longitudinal Acceleration Sensor 4P Connector Terminal No. 1
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -Replace the yaw rate-lateral/longitudinal acceleration sensor (see YAW RATE-LATERAL/LONGITUDINAL ACCELERATION SENSOR REPLACEMENT ).
NO -Repair an open in the wire between the No. 29 (10 A) fuse in the under-dash fuse/relay box and the yaw rate-lateral/longitudinal acceleration sensor.