Input Shaft (Mainshaft) Speed Sensor Replacement
- Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
- Remove the splash shield (see
SPLASH SHIELD REPLACEMENT
).
- Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor.
- Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
- Install the splash shield (see
SPLASH SHIELD REPLACEMENT
).