Center Console Panel Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the front seat, the dashboard, or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when Identifying components.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Remove the dashboard center trims both sides (see DASHBOARD CENTER TRIM REMOVAL/INSTALLATION ).
Remove the screws securing the center console panel (A).

Fig 1: Identifying Center Console Panel And Fastener Location
Courtesy of AMERICAN HONDA MOTOR CO., INC.
A/T: Apply the protective tape (A) to the A/T shift panel (B) along the side edge of the shift lever boot base (C). Pry upon the edge of the shift lever trim with a flat-tipped screwdriver to release the hooks (D).

Fig 2: Identifying Protective Tape, A/T Shift Panel, Shift Lever Boot Base And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
M/T: Lower the shift lever boot (A) to release the hooks (B) from the boot, then remove the shift knob (C).

Fig 3: Lowering Shift Lever Boot To Release Hooks From Boot
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips by pulling up the A/T shift panel (A). Disconnect the seat heater switch connectors or seat ventilation switch connectors (B) and the A/T gear shift position indicator light connector (C) (A/T).
NOTE: A/T is shown; M/T is similar.

Fig 4: Identifying A/T Shift Panel, Ventilation Switch Connectors And Light Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips by pulling up the center console panel (A). Disconnect the accessory power socket connector (B), then remove the console panel.

Fig 5: Identifying Center Console Panel And Power Socket Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the console panel in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Push the clips and the hooks into place securely.