LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2012 >> TL Base >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI System >> DTC Troubleshooting >> DTC P060A: ECM/PCM Internal Control Module Malfunction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P060A: ECM/PCM Internal Control Module Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
  1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  2. Clear the DTC with the HDS.
  3. Check for Pending or Confirmed DTCs with the HDS.

    Is DTC P060A indicated? 

    YES  - Go to step 4.

    NO  - Intermittent failure, the system is OK at this time. ■

  4. Update the ECM/PCM  if it does not have the latest software (see ECM/PCM Update ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ).
  5. Check for Pending or Confirmed DTCs with the HDS.

    Is DTC P060A indicated? 

    YES  - If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the ECM/PCM was substituted, go to step  1.

    NO  - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM  (see ECM/PCM Replacement ). If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting. ■

scientia non olet · About LEMON Manuals