Power Tilt/Telescopic Steering Switch Test/Replacement

Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ).
Disconnect the 13P connector (A) from the power tilt/telescopic steering switch (B).

Fig 1: Identifying Power Tilt/Telescopic Steering Switch 13P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Power Tilt/Telescopic Steering Switch Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the switch.
Install the parts in the reverse order of removal.