DTC P0451: FTP Sensor Circuit Range/Performance Problem
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- If DTC P2422 is stored at the same time as DTC P0451, troubleshoot DTC P2422 first, then recheck for DTC P0451.
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
- Clear the DTC with the HDS.
- Start the engine, and let it idle for 1 minute.
- Monitor the OBD STATUS for DTC P0451 in the DTCs MENU with the HDS.
Does the screen indicate FAILED?
YES - Go to step 5.
NO - If the screen indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. If the screen indicates NOT COMPLETED, keep idling until a result comes on.
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
- Replace the FTP sensor; without SH-AWD (see FTP SENSOR REPLACEMENT ), with SH-AWD (see WITH SH-AWD ).
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
- Reset the ECM/PCM with the HDS.
- Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
- Start the engine, and let it idle for 1 minute.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0451 indicated?
YES - Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM, then go to step 1.
NO - Go to step 12.
- Monitor the OBD STATUS for DTC P0451 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES - Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 11, go to the indicated DTC'S TROUBLESHOOTING .
NO - If the screen indicates FAILED, check for poor connections or loose terminals at the FTP sensor and the ECM/PCM, then go to step 1. If the screen indicates NOT COMPLETED, keep idling until a result comes on.