DTC 113: Yaw Rate-Acceleration Sensor Power Source Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
- Disconnect the yaw rate-acceleration sensor 4P connector (see YAW RATE-ACCELERATION SENSOR REPLACEMENT ).
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
- Measure the voltage between body ground and yaw rate-acceleration sensor 4P connector terminal No. 1.Fig 1: Measuring Voltage Between Body Ground And Yaw Rate-Acceleration Sensor 4P Connector Terminal No. 1
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -Replace the yaw rate-acceleration sensor (see YAW RATE-ACCELERATION SENSOR REPLACEMENT ).
NO -Repair an open in the wire between the No. 6 (7.5 A) fuse in the driver's under-dash fuse/relay box and the yaw rate-acceleration sensor.