VSA Modulator-Control Unit Removal and Installation: Installation

Install the VSA modulator-control unit (A) onto the bracket (B), then tighten the TORX bolts (C).

Fig 1: Bracket, VSA Modulator-Control Unit And TORX Bolts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the VSA modulator-control unit (A) with the bracket (B) to the body, then install the wire harness clips (C) and the VSA modulator-control unit bracket mounting bolts (D).

Fig 2: Wire Harness Clips, VSA Modulator-Control Unit, Bracket And Mounting Bolts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Align the connecting surface of the VSA modulator-control unit 47P connector (A) to the VSA modulator-control unit.

Fig 3: Identifying VSA Modulator-Control Unit 47P Connector, Lever & VSA Modulator-Control Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull down the lever (B) of the VSA modulator-control unit 47P connector, then confirm the connector is fully seated.
Connect the 10 mm brake lines and the 12 mm brake lines to the VSA modulator-control unit (A).
NOTE: Brake lines are connected to the master cylinder (B), the left-front (C), the right-front (D), the left-rear (E), and the right-rear (F) brake systems.

Fig 4: Master Cylinder, Left-Front, Right-Front, Left-Rear And Right-Rear Of Brake Systems With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the suction line mounting bolt (A) to the bracket.

Fig 5: Suction Line Mounting Bolt With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
Install the left and right engine compartment covers (A) (see ENGINE COMPARTMENT COVER REPLACEMENT ).

Fig 6: Identifying Left And Right Engine Compartment Covers
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Do the VSA modulator-control unit update (see VSA MODULATOR-CONTROL UNIT UPDATE ).
Do the VSA sensor neutral position memorization procedure (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).