Keyless Access System Registration: Procedure

How to use this service information .

NOTICE: 

When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.

1. Keyless Access System - Registration
   NOTE:

   • Check for aftermarket electrical equipment that could cause problems with keyless access operation.
   • While doing the registration, keep the remote away from computers.
   • Programming the remote also programs the keyless transmitter.
   • The body control module can store codes up to 6 remotes.
   • When each unit is replaced, such as updating and learning may be necessary in some cases, also make sure the "After Installation" of each unit.

   When Replacing the Body Control Module 

   Preconditions 

   • Connect the HDS to the data link connector (HDS) .

   Procedure 

   • Do the registration according to the "Immobilizer Setup Tool" screen.

   After Registration 

   • Verify all remote related functions works normally with all remotes.

   When Replacing the PCM, the TCM, the VSA Modulator-Control Unit, the Telematics Control Unit, or Registration of the Remote(s) 

   Preconditions 

   • Connect the HDS to the data link connector (HDS) .

   Procedure 

   1. If all remotes are lost, select "Immobilizer Setup Tool", and turn the vehicle to ON mode according to the instructions on the HDS screen, then go to step 4.

   2. Turn the vehicle to the ON mode.

   3. Select "Immobilizer Setup Tool".

   4. Select the appropriate selection, and do the registration according to the instructions on the HDS screen.

   After Registration 

   • Verify system works normally with all remotes.