Second Row Seat One-Touch Access Switch Test: Test
How to use this service information .
NOTICE:
When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.
Seat Cushion Side
- One-Touch Access Switch - Test
Preconditions
Left Second Row Seat Cushion Side (Figure 1)
Figure 2
Right Second Row Seat Cushion Side (Figure 3)
Figure 4
Procedure/Specifications
- Check the switch according to the table. (Figure 1, 2, 3, and 4)
NOTICE:
- When an LED is located between terminals, check if the LED lights by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
Result
- If the result is not as specified, replace the one-touch access switch .
Seat-Back Side
- Check the switch according to the table. (Figure 1, 2, 3, and 4)
- One-Touch Access Switch - Test
Preconditions
Left Second Row Seat-Back Side (Figure 1)
Figure 2
Right Second Row Seat-Back Side (Figure 3)
Figure 4
Procedure/Specifications
- Check the switch according to the table. (Figure 1, 2, 3, and 4)
NOTICE :
- When an LED is located between terminals, check if the LED lights by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
Result
- If the result is not as specified, replace the one-touch access switch .
- Check the switch according to the table. (Figure 1, 2, 3, and 4)