Confirmation Procedure

Perform the following procedures in order. If the failure is duplicated, the confirmation procedure is completed.

• Procedure 1
• • Turn the vehicle to the OFF (LOCK) mode, and allow the engine to cool below 104 deg.F (40 deg.C).
  • Start the engine, and let it idle without load (CVT in P or N, M/T in neutral).

• Procedure 2
• • Turn the vehicle to the ON mode.
  • Select the HDS [EX-VTC].
  • If the test result is not OK, the failure is duplicated.

• Procedure 3
• • Turn the vehicle to the OFF (LOCK) mode, and allow the engine to cool below 104 deg.F (40 deg.C).
  • Test-drive the vehicle at a steady speed between 19 - 37 mph (30 - 60 km/h) for 10 minutes.
  • Confirm the HDS [EX VTC Status] is ON.

    NOTE:  Let it idle until the HDS [EX VTC Status] turns to ON.

  • Monitor the HDS [OBD STATUS (PGM-FI)] for DTC P0366.