Integrated Dynamics System Switch Test: Test

How to use this service information .

NOTICE: 

When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.

1. Integrated Dynamics System Switch - Test

   Preconditions 

   • Center Console Center Panel Removed - Refer to: Center Console Area (2025) or Center Console Area (2022 2023 2024)

   Procedure/Specifications 

   • Check the switch according to the table. (Figure 1 and 2)

     NOTICE: 

     • When an LED is located between terminals, check if the LED lights by connecting power and ground to the LED.
     • Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

   Figure 1 

   Courtesy of HONDA, U.S.A., INC.

   Figure 2 

   Courtesy of HONDA, U.S.A., INC.

   Result 

   • If the result is not as specified, replace the integrated dynamics system switch .