LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1986 >> 5000 CS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - BOSCH Cis-E >> Testing >> Electrical Components >> After Start Enrichment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

After Start Enrichment

  1. Connect test harness between differential pressure regulator and vehicle harness. Connect multimeter to test harness. Disconnect wiring from coolant temperature sensor and leave open. Ground high tension lead (terminal No. 4) from ignition distributor.
  2. Crank starter for 3 seconds. Let key return to "ON" position. Differential pressure regulator current reading should increase to more than 120 mA for 20-50 seconds, then return to 80-110 mA range.
  3. If not, check starter signal to terminal No. 24 of ECU connector. Check signal from relay board to starter motor (terminal No. 15a on starter). On 5-cylinder vehicles, check voltage between ECU terminals No. 2 and 21. See VOLTAGE CHECKS and RESISTANCE CHECKS CHARTS for appropriate testing procedure. If all wiring is good, replace ECU.
scientia non olet · About LEMON Manuals