All Models
- Item Being Tested - Brake Light Switch Depress brake pedal. Voltage reading on ABS tester should be 10.3-14.5 volts. If reading is incorrect, check plug connector for brake light switch.
- Disconnect plug connector for brake light switch and install a jumper wire across connector. Repeat step 1). If voltage reading is now correct, replace brake light switch.
- If reading is still incorrect, check wires to brake light switch for voltage and terminal No. 25 in ABS control unit for continuity. See Figure . Turn ignition off before disconnecting control unit. If wires are okay, replace ABS control unit.